SUITABLE FOR:
Universal - glues wood, wood based materials, plastics (ABS, hard and soft PVC, Plexiglas®, polystyrene, Resopal®), metal, glass, porcelain, ceramic, leather, rubber, felt, cork, fabrics, cardboard, paper, many plastics and much more.
APPLICATION:
Directions for use:Apply the adhesive thinly to one side of the assembly, press the parts together - that’s it! For non-absorbent materials (e.g. ceramic, coated papers), apply to both sides of the assembly, leave to dry, re-apply and press the parts together.
Stains/residue: Remove wet glue stains immediately. Dried glue residue and glue stains in clothing can be removed with acetone.
Points of attention: Contains volatile, highly inflammable solvents. Appropriate precautions should therefore be taken during storage or when working with the adhesive.
CURE TIMES*
Drying/Curing time: approx. Bond strength: on beechwood test specimens tensile strength values (end values) of about 700 N/cm² have been obtained.
Final bonding strength after: approx. Approx. two thirds of the final strength are obtained after 24h.
* Curing time may vary depending on a.o. surface, product quantity used, humidity level and ambient temperature.
TECHNICAL PROPERTIES
Temperature resistance: The glue’s heat resistance is determined by the thermoplastic nature of its synthetic resin. Thus, glued parts should not continously be exposed to temperature above 70°C.
Chemicals resistance: Widely resistant against diluted acids, alkalines and also petrol and oil. NOT SUITABLE FOR: alcohols (e.g. denatured alcohol, white spirit), ketones (e.g. acetone), esters (e.g. ethyl acetate).
TECHNICAL SPECIFICATIONS
Appearance: colourless, highly transparent solution
Chemical base: polyvinylester
Consistency: Low viscosity
Viscosity: approx. 30 - 45 mPa.s.
Solvent: Mixture of low-boiling esters, ketones and alcohol
Solid matter: approx. 32-35 %
Density: approx. 0,97-0,99 g/cm³
Specifications: Electrical Data:
Specific volume resistivity (at 0,1 mm film thickness): 10^14 Ω x cm
Breakdown voltage (at 0,2 mm film thickness): 440 kV/cm
Surface resistance (at 0,2 mm film thickness): 2 x 10^11 Ω x cm
STORAGE CONDITIONS
Store in a dry, cool and frost-free place.
PHYSIOLOGICAL PROPERTIES
The dried adhesive is inert, completely neutral and physiologically indifferent.